Home / Our Products / Pulley Lagging
Pulley Lagging
When a Conveyor Belt slips,it causes significant damage to the drive pulley and the belt. Such damages are not only expensive to repair, but also time consuming and cause enormous loss due to down time. The life span of a conveyor system primarily depends on its being suitably equipped for the specific application and the standard of servicing and maintenance. The conveyor systems often have to perform in the most difficult conditions. For example rain and sludge, which cause slippage between the conveyor belt and pulleys because of the friction co-efficient between the two going down very low.
Patterned Sheet Pulley Lagging
Pulley Laggings, with specially developed rubber materials and their patterned surfaces have proved to be very effective in water shedding, preventing material build up and controlling belt slippage.
K. K. offers a comprehensive range of Patterned Sheet Pulley Laggings to suit every conceivable conveyor installation. The Pulley Laggings offered by K. K. are produced in different thicknesses, rubber qualities and patterns to ensure selection of the most appropriate type, to suit all application requirements.

The Sheet Pulley Laggings offered by K. K. come with CN Bonding Layers for better adhesion levels. The profiled patterns on the top surface, in diamond or square embossing improve belt grip and tracking on conveyors, while reducing belt wear. The Sheet Pulley Lagging is available in various grades of rubber, including N, FRAS and White Nitrile for packaging and food stuff carrying belts.

Special Features
  • Easy to install
  • Minimum wastage and economically priced
  • Reduced adhesive use due to Bonding Layer
  • Shorter lead times
  • Maintains friction grip under unfavourable drive conditions
  • Increased friction coefficient between the pulley and the conveyor belt
  • Extremely helpful while running in wet conditions
  • Prevents dirt build up in pulleys

Profile Diamond Profile Square Profile
Large Diamond Small Diamond Medim Diamond
Diagonal Length (mm) B 88 47 47 34 28
Diagonal Length (mm) L 48 27 27 17 28
Gap between the profile (mm) S 11 6 6 6 4.5
Depth of profile (mm) D 8 4.8 4 2.5 3
Minimum thickness (mm) T 15 8 8 6.5 8
Product Width (mm) 1500 1500 1000
1500 2000
Finish on face Plain Fabric Finish
Finish on the monding side With Bonding Layer (Adhesive / The gum Layer)
With Bonding Layer - Smooth or with Grinidng
Standard Roll Length (m) 10 * 10 * 10 * 10 * 10 *